Find the user manual and the help you need for the products you own at ManualsOnline. I got an old laptop model MA2 without powersupply. SetIP command to see and change the IP addresses of the console. This command can be used to change both Ethernet connectors and even set a gateway. Requirement: STP (shielded twisted pair) cable with RJ45 connector, min. Cat 5e . To connect Ethernet port 1: Connect one end of an Ethernet cable to the.

Author: Katilar Mutaur
Country: Panama
Language: English (Spanish)
Genre: Spiritual
Published (Last): 2 January 2012
Pages: 73
PDF File Size: 2.73 Mb
ePub File Size: 1.52 Mb
ISBN: 123-6-93876-586-7
Downloads: 75660
Price: Free* [*Free Regsitration Required]
Uploader: Mikarn

So either leg will suffice.

Set the IP address in the console

Further updates available via email. The substrate was about the size of an pencil eraser, and from there we had to add a custom chip, SMT caps, resistors and 12 gold filament wires. Ken Mon Aug 16, There should be no consequence, you’re simply bypassing an open circuit and there is nothing on the underside at that point.

Will run tests and report back.

I can’t seem to figure out what is wrong with this gateway ma2

What is the diode marked with? How do you test them if so?

  BRANDON AND TOOZE PDF

Thanks for getting back to me. I put a new port on the board. Then it is usually the AO Mosfet. No you should not, if the replacement supply doesn’t hum, it means that yours is going bad, unless it was not the same type or voltage.

Im not sure how to locate which is the Diode to be jumped or which mosfet to check. I would like to know to where you jumped it? Maybe these missing capacitor s took out part of the charging circuit? Manyal Hardware Thu Jun 17, Table of contents of this topic hide.

When shorted, it will read near zero in both directions. Meaker Sager Nov 22, My suggestion manal have the tech redo the jack. Further testing is necessary. I’ve been j-std and ipc certified.

Gateway Official Site: Worldwide

Jumper a thin wire from back of DC jack to the pair of legs on the diode [PD33] then give it a try turning it on. Mason Man Tue Jun 15, It could be leaking power with the Mosfets near the battery area. The charge light comes on then goes out. I can also see 19v at the battery charge port, but I can still not get the laptop to either charge the battery, or even run without the battery. If it is near zero ohms in either direction replace the chip. Neil Wed Jun 23, This makes sense though.

  ARRANCAME LA VIDA ANGELES MASTRETTA PDF

David Thu Oct 21, BTW the system will post off battery power.

Mayo Hardware Tue Mar 23, So Manyal do have quite a bit of hands on experience. Hope that helps somebody. I have a MA3 with a similar problem.

Connect Ethernet – grandMA2 User Manual – Help pages of MA Lighting International GmbH

Thanks again for your help! Looking at the picture, the post on the left is where I jumped to.

The shapers page Mon Oct 14, Iceman Sun Nov 20, Yesterday I got an MA3 working with the tip on jumping straight to the diode leg. Where should I solder to on the ma3? Well she’s working charging beside me just gatewag it should, I really appreciate your help. Any ideas would be greatly appreciated. Can’t seem to boot from external usb drive – XPS 15 boeNov 6,in forum: Mayo Hardware Wed Jun 23, You do have a defective repair.

Ken Mayo Hardware said Mayo Hardware Sat Dec 11,