Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout. ASTM C Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout. ASTM C/CM: Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout.

Author: Yokora Kagataur
Country: Laos
Language: English (Spanish)
Genre: Relationship
Published (Last): 14 April 2016
Pages: 465
PDF File Size: 2.19 Mb
ePub File Size: 10.32 Mb
ISBN: 992-8-86247-568-5
Downloads: 77896
Price: Free* [*Free Regsitration Required]
Uploader: Mazutaur

[email protected]: Testing of shrinkage for concrete – grout.

In both test methods, there is always a certain degree of friction between the specimen’s sides and the inner surface of the metallic mold. The height change results in both test methods are expressed in terms of percentage increase or decrease of the original specimen height.

It is the responsibility of the user of this standard to establish appropriate safety and health adtm and determine the applicability of regulatory limitations prior to use.

These test methods cover procedures for assessing the adhesion of coating films to metallic substrates by applying and removing pressure-s Newer Post Older Post Home. Combining values from the two systems may result in non-conformance with the standard.

Though not recommended by the ASTM standards, and in order to provide the lowest friction possible, an acetate sheet was used in between the test specimen and the mold.

  1N5824 DATASHEET PDF

Link to Active This link will always route to the current Active version of the standard.

Some values have only SI units because the inch-pound equivalents are not used in practice. An exception is made when c190 options described in the section on test conditions are exercised.

I married on 30 th June now having one b The alternative designation given in parentheses is for information only and does not represent a different standard sieve size.

The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. For cementitious grouts, saturate the surface up to SSD. Historical Version s – view previous versions c1900 standard.

ASTM International – Standard References for ASTM C / CM – 15

The height change of a 3-inch mm -diameter by 6-inch mm -tall cylindrical specimen was measured in accordance with ASTM C The glass plate was removed from the top of the test specimen after 24 h.

Sieve size is identified by its standard designation in Specification E After removal, the thickness of the glass plate was measured with a caliper at the points of contact between the glass plate and the micrometer. The laser approach has been compared with the original setup, and similar results were obtained. Two zstm specimens with the same dimensions as those used for the ASTM C test method were prepared in which the change in height was measured at four points on the top surface of the specimens using a micrometer in accordance with ASTM C at 1, 3, 7, 14, and 28 asmt see figure The degree of restraint varies with the mixture viscosity and degree of hardening.

  ASTM D374 PDF

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Testing of shrinkage for concrete – grout. This thickness was then added to the four-reading initial measurement. This approach provided more simplicity in the execution of the test, rather than using a projector lamp, magnifying lens, and indicator charts as described in ASTM C see figure